How we measure
Current reading
Each city is tied to its main airport weather station (shown on the city page). We use the sea-level pressure from the airport's latest hourly report (METAR) when it is at most 2 hours old and includes sea-level pressure; otherwise we show the forecast model's value for the city's coordinates and label it "model".
The forecast model and the airport rarely agree to the decimal; at some airports the model's sea-level value runs a few hPa higher or lower. So that the headline, the chart, the next-24-hours table and the week's lowest and highest agree with each other, we shift the model's whole sea-level line by the gap between it and the airport reading at the same hour. The shift is the same for every hour, so it changes no forecast change or fall. If the gap is more than 8 hPa we treat the airport report as suspect and show the model value instead.
Trend and changes
Units: US city pages show inches of mercury (inHg), miles and °F, as US forecasts do; Canadian city pages show kilopascals (kPa), kilometres and °C, as Environment and Climate Change Canada does. Every reading also shows hPa (the same as millibars), and all changes, falls and swings are given in hPa.
Readings, ranges and records are sea-level pressure, the figure weather reports use. Changes are different: converting to sea level adds a correction that depends on air temperature, and at high-altitude cities such as Denver that correction alone can move the number several hPa between afternoon and night without the air pressure actually changing. So every change on this site (trend, 3- and 24-hour changes, falls, swings, levels) is measured on pressure that is not reduced to sea level: the forecast model's surface pressure, and for the history, the airport's altimeter setting.
The 3-hour and 24-hour changes compare the model's hourly surface pressure now with 3 and 24 hours earlier. Following the usual barometer convention, a change smaller than 1 hPa in 3 hours is "steady", 1–3 hPa is "rising" or "falling", and 3 hPa or more is "rising fast" or "falling fast".
Pressure-change levels
Every local day gets a level from the larger of: the biggest fall in pressure that ends during the day and starts no more than 3 hours before midnight, or 70% of the day's swing between its lowest and highest hourly value. The lookback means an overnight fall counts for the day it continues into, while one storm is not counted again on the next day.
| Level | Change | What it usually means |
|---|---|---|
| Low | 0–4 hPa | Little change in pressure. |
| Moderate | 4–8 hPa | A noticeable change in pressure. |
| Elevated | 8–12 hPa | A large change in pressure. |
| High | 12 hPa or more | A rapid fall in pressure, the kind that comes with a strong storm system. |
The levels describe the atmosphere only. They are not a health forecast and do not predict headaches or pain.
Rapid drops and city statistics
A "rapid drop day" is a day on which pressure fell 12 hPa (0.35 inHg) or more within 24 hours, comparing each hourly reading with the reading 24 hours earlier (±1 hour if one is missing). A day counts as complete when it has at least 18 hourly readings. "Usual range" is the 5th to 95th percentile of complete days' average pressure; "typical daily swing" is the average difference between a day's lowest and highest reading; a "big swing" is 10 hPa or more. Monthly averages use complete calendar years only.
Cleaning the data
We drop readings outside 940–1065 hPa, single-hour spikes that jump more than 8 hPa away from both neighbouring hours, and any reading more than 6 hPa from the median of the surrounding seven hours (a median follows a real storm's steady fall, so only bad values are removed). Airport reports give sea-level pressure as its last three digits only, so a decoder can turn 1040.0 into 940.0; when that value disagrees with the altimeter setting in the same report by more than 25 hPa, we discard it. Records ignore days with fewer than six readings for the same reason. Readings are provisional and the agencies can revise them.
Updates
Current readings and forecasts are refreshed several times a day, and the history once a day. Each page shows when its reading was taken.
Sources and licences are listed on the data sources page.